CASH
®
Magnum XL
SERVICING
P25
SECTION
10
©
DO NOT ATTEMPT TO USE THIS STUNNING TOOL UNTIL YOU HAVE READ AND
UNDERSTOOD THESE INSTRUCTIONS.
ALWAYS WEAR THE CORRECT PERSONAL PROTECTIVE EQUIPMENT (PPE) WHENEVER YOU
ARE WORKING WITH, CLEANING OR MAINTAINING YOUR CASH MAGNUM XL TOOL.
ALWAYS WEAR PROTECTIVE GLASSES AND HEARING PROTECTION. THE CORRECT
FOOT PROTECTION MUST BE WORN. THERE IS A RISK THAT IF THE TOOL IS DROPPED,
THE BOLT MAY PENETRATE THE FOOT OF THE TOOL USER.
ONLY PERSONNEL WHO HAVE BEEN AUTHORISED TO DO SO SHOULD CONDUCT ANY
RECTIFICATION INDENTIFIED IN THIS TROUBLESHOOTING SECTION
TO DIS-ASSEMBLE STOP FIRE MECHANISM (ITEM 15A)
1
Turn clockwise to fire (RED DOT) position and drive safety stop pin (Item 15) down through safety cap inner (Item 12)
with a pin punch.
2
Then unscrew safety cap outer (Item 14) anti-clockwise to remove.
3
Clean with Young’s 303 fluid and brass brush end of cleaning tool.
4
Inspect for cracks or stripped threads and replace if found.
5
Replace safety ‘O’ ring (Item 13) if broken or frayed.
RE-ASSEMBLY OF STOP FIRE MECHANISM
1
Lightly oil or grease threads with Copaslip.
2
Align the small dimple on the end face of the safety cap inner with the cut out in the lower edge of the safety cap
outer - this will ensure that the 3 start thread commences location in the correct position, so that when screwed
together clockwise, the cut out on safety cap outer aligns precisely with the “RED DOT” mark on the inner cap,
which should be fully visible.
3
Insert safety stop pin and drive flush with top of safety cap outer (if pin is driven too far, the assembly will not turn).
4
Re-assemble on firing pin assembly and screw down tight on breech cap, using wrench on flats of inner safety.
5
If outer safety cap is used to screw or unscrew safety from breech cap, you will break the safety stop pin.
ONLY EVER USE GENUINE ACCLES & SHELVOKE REPLACEMENT PARTS
Accles & Shelvoke provide a comprehensive service and repair facility where customers can have their CASH stunner
serviced by our highly experienced and trained engineers. This service is generally open to UK customers. Overseas
customers are advised to contact their local distributor.
4
A quotation will be provided on inspection of the return of the tool, itemising service charges and replacement parts required.
4
The service involves the tool being stripped, cleaned and reassembled with the replacement parts quoted to return the
tool back to good working order.
Customers are advised to contact Accles & Shelvoke direct on +44(0)121 313 3564 to make arrangements to return the
tool for service and repair.
