NOTE:
1. The Glide Effect function can be switched on(YES) or off(NO). The transition from one level to another is
smoother when this function is switched on.
2.Master Control
(1) AUTO mode:
(2) MANUAL mode:
AUTO mode and MANUAL mode are for Master Control. Relevant functions are as below:
Preset programs:1-10 programs and "AUTO" program (
program is the sequential running of these
1-10 programs.)
"AUTO"
Auto Speed: 1~100. Auto Fadetime: 0%~100%.
BLUE/Duration: 0%~100%. RED/Speed:
.
0%~100%
GREEN/Dimmer:
.
0%~100%
1. The LEDs will turn red in Slave Control mode.
The LEDs will give responding sensitive when the parameters are adjusted in Master Control.
1. Slave Control
Red color effect is controlled by Channel 1.
Green color effect is controlled by Channel 2.
Blue color effect is controlled by Channel 3.
In Slave control, Address setting (
) and Glide effect function can be
set through a LED Setup Tool(sold separately). In RGB, C&B and COLOR
mode, relevant controls are as below:
001~512
(1)In RGB mode:
Color effect is controlled by Channel 1.
Brightness is controlled by Channel 2.
(2)In C&B mode:
Color effect is controlled by Channel 1.
Brightness(lighting intensity) is always in 100% level.
(3)In COLOR mode:
A LED Setup Tool (depicted here) _XB-R1 is required to program
the Rebel-Bar-350. For further information, please refer to its
accompanying manual.
A LED Setup Tool(XB-R1)
(Sold separately)
OPERATION GUIDE(PROGRAMMING)
-2-
When the user confirms the settings of the LED products, the LEDs will flash momentarily to confirm that the
settings have been saved.
2. If the LED is not selected in "Setup with answer", it will turn red.
If the LED is not selected in "Setup no answer", it will switch off.
3. If the DMX signal is interrupted, the driver will keep the last received DMX signal(information) until the driver
is switched off or a new and valid DMX signal is sent.
2. When this function is switched off, the lighting intensity will changed from one level to another abruptly. (Thus,
when a quick lighting effect is required, the Guide Effect function should be switched off.)
NOTE:
For Rebel-Bar-350 RGB version
