Acclaim Lighting Flood One EO Series, User Manual

Page: 9 / 20

7
www.acclaimlighting.com
USING A PIPE CLAMP
Optional pipe clamps are available to mount Flood One EO fixtures on either 2” (50mm) or 4”
(100mm) tubes and poles.
IMPORTANT: Ensure the pipe and its mountings have sufficient load capacity for the
Flood One EO fixture(s) to be mounted.
TO USE A PIPE CLAMP
1 Separate the two halves of the
clamp, if they are already bolted
together.
2 Place the two halves of the
clamp around the pipe.
3 Use the two longer
bolts, one from each
side to join the two
halves - see below
about the correct
use of the supplied
washers.
4 Tighten the two main
bolts evenly until the
clamp is held firmly in
place.
5 Use one of the two
smaller bolts (with
spring and standard
washers) to fix the Flood
One EO yoke to one side of the
clamp and tighten.
(2 off)
M10 x 50mm
Using the supplied washers
The supplied spring washers
help to maintain tension on the
bolts to prevent loosening.
Always place the spring
washer on each bolt
first and then add
the standard washer,
before inserting the
bolt into the clamp.
This will prevent the
steel spring washer
from denting the softer
aluminum body of the
clamp.
(1 off)
M10 x 25mm