NOTE:
1) You must follow the operating instructions mentioned above, any malfunction is not allowed during adjustments. If your device responds
to your requested function correctly, you have successfully configured the function, otherwise repeat the above setup instruction until your
device responds to the requested function.
2) If the door cannot be moved, please check if the door is obstructed or the door is too heavy.
3) Remote control: Each push of the button makes the door able to: close, stop, open or stop its cycle (Single channel mode). Or the first
button is to open, the second button to close, and the third button is to stop (Multi-channel mode).
4) Three-Button Mode, External Switch Button (not included). Press the "OPEN" button to open the door. Press "STOP" to make the door stop.
Press “CLOSE” for the door to close.
5) Single button mode, external switch / keyboard button (not included). With each push of the button, the door closes, stops, opens or stops
the cycle.
Automatic closing function:
1) This feature can be selected to make the door stay open for a few seconds before it closes automatically. The automatic closing can be
adjusted between 1, 10 and 30 seconds.
2) Safety device (Infrared photocell): If the infrared beam is interrupted during closing, the door will turn back and open immediately. This
feature will not work if the door is in the fully open and closed position during opening.
3) Opening priority: The door will reopen if the “OPEN” button of the external switch button is pressed during closing.
4) Limit switch: the switch is used to precisely stop the door in the open and close positions. If the door stops in the open position when the
switch limit is reached, the door will not move if you press the “OPEN” button. If the door stops in the closed position when the switch limit is
reached, the door will not move if the “CLOSE” button is pressed.
5) The device is installed with a thermal protector, the thermal protector will turn off the motor automatically in case the temperature is
higher than 120 ° C and it will start the motor automatically when the temperature is less than 85 ° C ± 5 ° C.
Maintenance.
1) Check the door once a month. The door must be carefully checked for balance. The door must be in good working order.
2) It is recommended for safety reasons that photocells be used on all doors.
3) Disconnect the mains or power supply before replacing the bulb.
4) Be sure to read the entire manual before attempting any door operator installation or service.
5) Our company reserves the right to change design and specifications without prior notice.
Opening your life
Code:
PB400
www.accessmatic.com
Opening your life
1
