5
A. Unroll cover and place rear bar into
strikes on side rails and press down on bar
to close (20-30 pounds pressure).
4. INITIAL OPERATION AND ADJUSTMENTS
B. Close tailgate slowly - top of tailgate
should fit snug under cover bar. If tailgate
rubs bar too hard, raise rails by loosening
rear clamps, adjust rails up and retighten
clamps. If there is too much gap between
tailgate and cover bar, lower rails by
loosening rear clamps, adjust rails down
and retighten clamps. Check cover tension
by releasing trigger latch and open and
close rear bar several times. It should snap
down when closing.
C. Cover fabric should sound drumlike
when tapped on. If adjustment is needed,
roll cover open and
to loosen turn EZ-
Dial Clockwise. To tighten turn EZ-
Dial Counter Clockwise. Always turn
Dials in Equal amounts. See photo at left.
NOTE: For detailed operating instructions see page 6.
D.When done, seal both sides of cover with
hook and loop system.
To loosen Cover
Turn Clockwise
To Tighten Cover
Turn Counter
Clockwise
