INSTALL BATHTUB
1.
Apply a generous bead of adhesive or silicone to the
bottom of the tub supports (figure 6).
2.
Then apply a bead of tub and tile caulk around the edge
of the base (figure 6)
Figure 6
3.
Carefully set tub into position (figure 7) and connect
the drain hardware (previously installed). Finish the
installation of the tail-piece installation.
Figure 7
INSTALLATION
CONTINUED
CA
ULKING
COMPLETE BATHTUB INSTALLATION
19. Fill the tub with water to the overflow and then drain the
tub while inspecting the waste connections below the
floor for leaks. Access from below will be necessary for
this step (figure 8).
Figure 8
20. With the bathtub now in place, wipe off any excess tub
and tile caulk and adhesive where the tub meets the floor.
21. Run a bead of tub and tile caulk around the bottom edge
of the bathtub where it meets the floor. Wipe off any
excess caulk with a wet cloth (figure 9). If the tub must be
uninstalled for maintenance or repair completely remove
the caulking. Afterwards throughly clean the bottom of the
shell and reapply caulking.
Figure 9
Summary of Contents for ROYALE
Page 2: ......
Page 8: ...INSTALLATION CONTINUED ...
Page 15: ...NOTES INSTALLER INFORMATION DATE OF INSTALL INSTALLER S NAME PLUMBER CONTRACTOR LICENSE ...
Page 16: ......