AWP 3260 CWH
Installation Instructions
Hydro-massage Bathtub - UL 1795
Thank you for purchasing Praxis Bathware. For best results,
please read and follow all directions carefully.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE,
ELECTRICAL SHOCK OR INJURY TO PERSONS.
WARNING- When using this unit, basic precautions should
always be followed, including the following:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. DANGER: To reduce the risk of injury, do not permit
children to use this unit unless they are closely supervised at
all times.
3. Use this unit for its intended use as described in this
manual. Do not use attachments not recommended by
manufacturer.
4. Never drop or insert any object into any opening.
5. Do not operate unit without guard over suction fitting.
6. The unit must be connected only to a supply circuit that
is protected by a ground-fault circuit interrupter (GFCI).
Such a GFCI should be provided by the installer and should
be tested on a routine basis. To test the GFCI, push the
test button. The GFCI should interrupt power. Push the
reset button. Power should be restored. If the GFCI fails to
operate in this manner, the GFCI is defective. If the GFCI
disrupts power to the bath without the test button being
pushed a ground current is flowing indicating the risk of
electrical shock. Do not use this hydro-massage bathtub.
Disconnect the hydro-massage bathtub and have the
problem corrected by a qualified service representative
before using.
7. A grounding lug is provided on the exterior of the control
panel (where applicable) and pump to permit connection of
a No. 8 solid copper bonding conductor between this unit
and all other electrical equipment and exposed metal in the
vicinity, as needed to comply with local requirements.
8. SAVE THESE INSTRUCTIONS.
PRECAUTIONS
READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
Inspection:
Upon receipt of the Whirlpool Bath, inspect
it thoroughly for damage or shortage. Verify that the
unit specifications are correct. If damage or shortage has
occurred notify the distributor or freight carrier immediately.
Under no circumstances should a damaged or defective
unit be installed without prior factory approval. Neither
Praxis Companies nor the distributor will be responsible for
removal or re-installation costs should replacement of the
unit be necessary.
Testing:
Follow all testing procedures. While each unit is
factory water tested, the shipping process may result in
damage to, or loosening of the pipe joints and connections.
Keep the unit covered during and after installation to
prevent damage to the surface of the bath.
Do not lift the unit by the piping. Lift only by the bath’s deck.
Never attempt to run the pump/motor while the whirlpool
is dry.
All plumbing and electrical connections should be made by
licensed, qualified plumbers
and electricians.
Tools you might need for proper installation
•
galvanized nails or screws
•
large level
•
hammer or screw gun
•
shims
•
adhesive
