Access One WVD100, Product Manual

Page: 14 / 24

WVD100
Product Manual
WVD100, Rev 2.5E Page 14
EZ Loop
Installation
S600SM Sensor Direction:
The detection area is rectangular and is approx. 8ft wide x 4ft
deep. To properly orientate the sensor, direction arrows are
located on the baseplate and sensor cover.
1. Locate the direction arrows on the sensor cover.
2. Point the direction arrows toward the gate parallel with the line of
traffic.
Installing The S600SM Sensor With Epoxy:
The sensor can be secured to the driveway with screw anchors or
a standard concrete epoxy. To mount the sensor using epoxy:
1. Select the sensor location and test the sensor before securing it.
Make sure it tests properly and drops detect in the full open or full
closed position.
2. Using an epoxy such as Loctite or JB Weld, spread the epoxy on the
bottom of the baseplate and press to the driveway.
In rare instances such as extreme traffic or
vandalism prone applications, a stronger epoxy
might be needed. In such applications a cement
epoxy similar to what is used to hold down
highway reflectors can be used. One source we
recommend is:
https://stop-painting.com/order_form.asp
Stop-Painting.com
AP-43 Epoxy Kit for Road Reflectors—One Quart
Installation
Installing The Sensor With Anchors:
The sensor can be secured to the driveway with four 1/4” Flat
Head Sleeve Anchors. To mount the sensor using anchors:
1. Select the sensor location and test the sensor before securing it.
Make sure it tests properly and drops detect in the full open or full
closed position.
2. Open the sensor and locate the four anchor mounting holes on the
baseplate.
3. Drill out the holes on the baseplate so the anchor screw can pass
through. Then mark the location of each hole.
4. Drill and clean the anchor holes. (A 5/16” drill bit is commonly used.)
5. Drive the anchor though the baseplate and into the anchor hole and
tighten the anchor screw until the baseplate is secure.
6. IMPORTANT: The anchor screws must be tightened all the way
down and cannot stick up above the top of the baseplate.
If it is
not, it will not allow the unit to seal properly.
Driveway
Anchor
Hole
Anchor
Hole
CORRECT:
Flush or below
INCORRECT:
Not Flush or below