ACCES I/O Products, Inc.
MADE IN THE USA
mPCIe-ISODIO-16 User Manual
5
Rev B1
C
HAPTER
8:
S
PECIFICATIONS
PC Interface
PCI Express Mini Card
Type F1 “Full Length”
Isolated Inputs
Number
8
Voltage
Logic High
Logic Low
2.0V to 5V
0V to 0.8V
Isolated Outputs
Number
8
Voltage
Logic High
Logic Low
Power Output
2.0V (min), source 32mA
0.55V (max), sink 64mA
+3.3VDC via 50mA polyfuse
(resetting)
Environmental
Temperature
Operating
0°C to +70°C
-40°C to +85°C (-T option)
Storage
-65°C to +150°C
Humidity
5% to 95% RH, non-condensing
Power Required
+3.3VDC
+1.5VDC
500mA
415mA
Physical
Weight
7.2g
Size
Length:
Width:
50.95mm (2.006”)
30.00mm (1.181”)
I/O connectors
On-card:
Molex 501190-2017 20-pin latching
Mating
Molex 501189-2010
On-cable
Female, D-Sub Miniature, 25-pin
Mating
Male, D-Sub Miniature, 25-pin
Isolation
Tru-Iso
IPC-2221B
I/O to PC
1500 V peak (AC or DC)
UL-1577
UL recognition (pending): 5000 V rms for 1 minute
Careful attention has been paid to isolation design, including extensive keep-out zones and
hand-routed circuit paths, as well as component and material selection.
C
HAPTER
9:
C
ERTIFICATIONS
CE & FCC
These devices are designed to meet all applicable EM interference
and emission standards. However, as they are intended for use
installed on motherboards, and inside the chassis of industrial
PCs, important care in the selection of PC and chassis is important
to achieve compliance for the computer as a whole.
UL & TUV
No AC or DC voltages above 31V are consumed or produced
during normal operation of this device. This product is therefore
exempt from any related safety standards. Use it with confidence!
ROHS / LEAD-FREE STATEMENT
All models are produced in compliance with RoHS and various
other lead-free initiatives.
WARNING
A SINGLE STATIC DISCHARGE CAN DAMAGE YOUR CARD AND
CAUSE PREMATURE FAILURE! PLEASE FOLLOW ALL
REASONABLE PRECAUTIONS TO PREVENT A STATIC
DISCHARGE SUCH AS GROUNDING YOURSELF BY TOUCHING
ANY GROUNDED SURFACE PRIOR TO TOUCHING THE CARD.
ALWAYS CONNECT AND DISCONNECT YOUR FIELD CABLING
WITH THE COMPUTER POWER OFF. ALWAYS TURN
COMPUTER POWER OFF BEFORE INSTALLING A CARD.
CONNECTING AND DISCONNECTING CABLES, OR INSTALLING
CARDS, INTO A SYSTEM WITH THE COMPUTER OR FIELD
POWER ON MAY CAUSE DAMAGE TO THE I/O CARD AND
WILL VOID ALL WARRANTIES, IMPLIED OR EXPRESSED.
WARRANTY
Prior to shipment, ACCES equipment is thoroughly inspected and
tested to applicable specifications. However, should equipment
failure occur, ACCES assures its customers that prompt service
and support will be available. All equipment originally
manufactured by ACCES which is found to be defective will be
repaired or replaced subject to the following considerations:
GENERAL
Under this Warranty, liability of ACCES is limited to replacing,
repairing or issuing credit (at ACCES discretion) for any products
which are proved to be defective during the warranty period. In
no case is ACCES liable for consequential or special damage
arriving from use or misuse of our product. The customer is
responsible for all charges caused by modifications or additions to
ACCES equipment not approved in writing by ACCES or, if in
ACCES opinion the equipment has been subjected to abnormal
use. "Abnormal use" for purposes of this warranty is defined as
any use to which the equipment is exposed other than that use
specified or intended as evidenced by purchase or sales
representation. Other than the above, no other warranty,
expressed or implied, shall apply to any and all such equipment
furnished or sold by ACCES.
