Acard AHARD RAID 66, User Manual

Page: 9 / 21

AHARD RAID 66
6
! !
! ! !
For each connector port on AHARD RAID 66 to connect with hard
disk, either same connector cable can not be set as both “Master” or
both “Slave”.
! !
! ! !
In order to get a better performance, please use same model or brand
hard disk and Ultra DMA 66 or 100 hard disk.
Normal Mode
! !
! ! !
Two AHARD RAID 66 card IDE connector port as normal IDE port
extension.
! !
! ! !
When using two hard disks connected with AHARD RAID 66 at the
same IDE port (on same cable) by one connector cable please
identify that the hard disk jumper must be set as one “Master” and
one “Slave” position on each hard disk. The two hard drive can not be
set as both “Master” or both “Slave”.
! !
! ! !
If using two IDE connector port on AHARD RAID 66 to connect with 4
hard disks, jumpers setting and hard disks boot sequence will follow
the jumpers setting from IDE 1 Master, Slave and then IDE 2 Master,
Slave.
! !
! ! !
In order to get a better performance, please use Ultra DMA 66 or 100
hard disk.