Installation
43 |
EN
Note:
for software < = 1.8 or for FUSG50100
•
Select:
Installer Mode -> Components -> Outdoor sounders -> Wireless sounders ->
Add/remove sounders -> Wireless sound. 0x
The message “Activate the tamper contact of the sounder” is displayed.
Leave the alarm panel in this state during the next step.
•
Connect the two batteries to the sounder, taking care to observe correct polarity (see Fig. 2).
Caution
and
important
The sounder or the batteries could get damaged if correct polarity is not observed.
The sounder then sends a teach-in signal to the alarm panel. The alarm panel
recognises the sounder and the notification “Sounder added” is displayed. If this
notification is not displayed, disconnect the batteries and reconnect them after waiting
30 seconds.
Note
The batteries are already connected.
Disconnect the batteries and reconnect them so that the sounder sends the teach-in
signal to the alarm panel.
Figure 2: Battery connector
•
Disconnect the batteries again to prevent the sounder activating itself. Do
not
exit installer
mode on the alarm panel.
