15
6. Function Settings
6.1 Reverse Function
The Reverse function is used to correct a servo or motor's
direction in relation to the systems controls. For example, if a
steering servo is mounted upside down in order to fit inside a
model, when the system's steering wheel is turned, the servo
will move in the oppisite direction. To fix this, all we need to do
is reverse CH1.
To reverse a channel:
Touch the channel in the list. When reversed, the slider will be at
the [
REV
].
Select the
icon to return to the previous menu.
Select the
icon to reset the function.
6.2 End Points Function
Endpoints are the limits of the channels' range of movement. There are two endpoints, one is the low
endpoint and one is the high end point.
To set an endpoint:
1. Move the desired control surface in the direction you
wish to change. The currently selected endpoint will be
highlighted in yellow.
2. Touch the channel you wish to change. The setup menu for
the selected channel displays.
•
At the top of the current channel, the selected endpoint
and percentage are shown.
•
The endpoints location is shown as a bar and needle.
•
The red needle indicates the current setting for the
selected side and channel.
•
A real time readout of the channels position can be
seen in this menu as a green bar.
3. Move the wheel at the bottom of the screen left to reduce
the value or right to increase the value.
Select the
icon to return to the previous menu.
Select the
icon to reset the function.
