Absco Industries
Assembly Instruction Manual
LARGE GABLE SHED
N3/C1 FRAME KIT
FOR WORKSHOP & UTILITY MODELS
Model: CYCWKUTK
02/03/21
1.3
20
BRACING FOR GABLE WALLS
Construction for the gable walls is similar to the non-gable wall.
1. Take two C2750 frame pieces for the gable wall, and partially box them together,
do not tek screw
yet
.
2. Place the unscrewed box section against the previously installed wall bracing and slide the two
pieces apart until they make contact with it and the brace on the other wall. This is shown below.
3. Now the framing is at the correct length proceed to fix them together as per method described in
BOXING FRAME SECTIONS.
4. Now boxed use tek screws to fix it to the gable wall from the outside of the shed. This is best done
with two people.
Gable wall
Gable wall
Non-gable wall
Previously installed wall bracing on the left and
new gable wall bracing on the right.
5. Use corner brackets (BKT10) to secure the rear,
side and front wall braces together. Position as
shown and fix using four tek screws. Pre-drilling
the bracket with a 3mm drill bit will make this
easier.
The other end of the same gable wall brace
butting up against the other previously installed
wall brace.
C2750
C2750
