Absco Industries
Assembly Instruction Manual
LARGE GABLE SHED
N3/C1 FRAME KIT
FOR WORKSHOP & UTILITY MODELS
Model: CYCWKUTK
02/03/21
1.3
21
ROOF BRACING
NOTE: This roof bracing will have to cut to suit
from part C2100.
1. Align the roof framing along the midpoint of
the roof, running perpendicular to the roof sheet
corrugations. This may require two people.
2. Using a marker trace along one edge of the
channel onto the roof sheet as shown.
Next measure 20mm in from this line and mark
again, this will the centreline of the bracing.
Proceed to drill a hole in every 2nd flat section of
the roof sheet.
3. Where the bracing meets the open side of the
portal frame it will need to be boxed as before
in section BRACING FOR NON-GABLE WALLS -
PORTAL FRAME.
4. While one person holds the roof brace in
position use tek screws to fix the framing from the
outside of the shed.
IMPORTANT: Do not sit, stand or walk on the roof
or apply unnecessary pressure of the sheeting
during this step.
5. Place a BKT17 to either end of the roof brace
using 8 tek screws as shown.
The roof lip may need to be removed in order
to fit the four tek screws from the outside of the
shed.
Two multipurpose
brackets, BKT17, are
used per roof brace.
