Absco Industries
Assembly Instruction Manual
SKILLION SHED
N3/C1 FRAME KIT
FOR SPACE SAVER AND
Model: CYCSKRSK
02/03/21
1.1
12
REVERSE SKILLION MODELS
BRACING FOR SIDE WALLS
Construction for the gable walls is similar to the back wall.
1. Take the two frame pieces for the side wall, and partially box them together,
do not tek screw yet
.
2. Place the unscrewed box section against the previously installed wall bracing and slide the two
pieces apart until they make contact with it and the brace on the other wall. This is shown below.
Now the framing is at the correct length proceed to fix them together and then use tek screws to fix it
to the side wall from the outside of the shed at 148mm spacings.
Side wall
Side wall
Back wall
Previously installed wall bracing on the left and
new side wall bracing on the right.
5. Use corner brackets (BKT10) to secure the rear,
side and front wall braces together. Position as
shown and fix using four tek screws. Pre-drilling
the bracket with a 3mm drill bit will make this
easier.
The other end of the same side wall brace
butting up against the other previously installed
wall brace.
C1220
C1220