PAGE 16
ABSCO INDUSTRIES
ASSEMBLY INSTRUCTION - MODEL: CYC4560 CYCLONE KIT 31/05/13
ASSEMBLY INSTRUCTIONS
CYC4560 CYCLONE KIT
START ON THE REAR SECTION NEXT. SELECT THE TWO CHANNELS THAT ARE USED FOR THE REAR
WALL, CONNECT THEM TOGETHER INTO A BOXED CONFIGURATION DO NOT TEK SCREW YET.
PLACE UNSCREWED BOX SECTION AGAINST REAR WALL AND SLIDE CHANNELS OUTWARDS UNTIL
THEY MAKE CONTACT WITH BOTH SIDE WALLS. THE END RESULT SHOULD BE SIMILAR TO BELOW.
CYCLONE KIT ASSEMBLY - REAR WALL RE-INFORCING
ONCE CHANNELS ARE AT CORRECT LENGTH PROCEED TO FIX THEM TOGETHER USING TEK SCREWS AT
EVERY 2ND CORRUGATION AS DESCRIBED ON PAGE 11.
ONCE CHANNELS HAVE BEEN SECURELY BOXED TOGETHER USE TEK SCREWS TO FASTEN THE
SECTION TO THE WALL FROM THE OUTSIDE OF THE SHED. THIS TASK IS BEST DONE WITH TWO PEOPLE
TIP: USE ANOTHER PIECE OF WOOD 890mm HIGH TO MARK THE DRILL HIEGHTS ON THE OUTSIDE OF
THE SHED.
COMPLETED BOXED SECTION MOUNTED TO REAR WALL.
BACK WALL
C2910 L = 2910mm
