![background image](http://html1.mh-extra.com/html/abs/ph-abt-ucfs-0204g/ph-abt-ucfs-0204g_owners-manual_3505339004.webp)
Part number 20220, Rev 0
4
INSTALLATION INSTRUCTIONS
UNCRATING
Move your refrigerator as close to the final
location as possible before unpacking.
Remove the carton and the styrofoam
strips. The location should be as close as
possible to the power outlet so no
extension cord is needed. This unit
requires a
minimum of 4 inches of air
flow space in back and 3 inches on the
sides and back.
LEVELING
You can level your unit with the screw-type adjustable leveling legs on the front corners of the
unit. Turn counterclockwise to raise the corner; turn clockwise to lower it. Leveling legs are
required in front only. Unit may have a slight tilt from front to back. This is acceptable and
is recommended on this unit.
POWER SOURCE
The supply circuit to this cabinet must
conform to all National and Local Electrical
Codes. Consult the cabinet Serial-Data
plate for voltage, cycle, phase, and amp
requirements before making connection.
VOLTAGE SHOULD NOT VARY MORE THAN
5% FROM SERIAL PLATE RATINGS. A
separate
circuit
is
recommended to prevent possible loss of product due to
over-loading or failure of other equipment on the same
circuit. PROTECT THE CIRCUIT WITH A 20 AMP DELAY-TYPE
FUSE OR CIRCUIT BREAKER. Do not use an extension cord.
Be sure your unit is properly grounded. Use the 3-prong
plug provided into a 3-prong grounded outlet. (Only this
method complies with national electrical codes, local codes
and ordinances.) Unless the above grounding method is
followed, you are not protected against severe or lethal
shock in the event of a short circuit of an electrical
component or wiring of the unit.