9/22 - Installation instructions for the OPEN SURF System and OPEN SURF System 2 above-water automatic slatted safety cover
9
3.3.2
2
nd
rail
Fig. 17
-
Place the rail parallel to the other. Place the
OPEN SURF on the rails and against the stop on the
first rail on the pool side.
-
Pre-drill all the holes to Ø 5 mm always keeping the
OPEN SURF close to the hole in order to maintain a
constant gap between the rails.
-
Push the rail aside to drill the Ø 8 mm holes and fix
the rail with the screws.
Fig. 17
3.4 Fixing the stand (SURF 1 and 2)
Fix the stand to the rear of the rail on the motor side of
the OPEN SURF.
Fig. 18
-
Place the OPEN SURF against the rear stop, place
the stand approximately 5 cm from it. For non solar
models, bring the power supply cable to the stand.
Fig. 18
Fig. 19
Power supply stand
-
Mark the 4 holes using the plate (6) and drill using
a Ø 12 mm bit.
-
Fit the threaded rods (5) using chemical sealer.
The rods must protrude 342 mm above the ground.
-
Fit the square tube (4) and connect the 24 volt input
cable using the supplied screw terminal.
-
Place the plate with the notch (3) and screw
the 4 bolts (2).
-
Place the top (1).
Fig. 19
1
2
3
4
6
5
Fig. 20
Solar end stand (SURF 1 only)
-
Mark the 4 holes using the base (1) and drill using
a Ø 1 mm bit.
-
Fit the M8 anchors (3) and the FHC M8 x 60 (2) screws
to fix the base.
-
Fit the base (4).
-
Adjust the orientation of the stand so that the solar
panel faces south. Then, screw the CHC M6 x 16 screw
(5) in order to block the base rotation.
-
Place the cover (6) on the base and fix it using the
4 plastic screws (8).
-
Place the casing (7) on the casing (6) and fit it using
the plastic screws (9).
Fig. 20
3
1
2
4
6
8
7
5
9
