The tread belt
is slipping
Tread belt is too loose or too tight. Adjust the tread belt tightness
to the correct tension. The tread belt should be able to be lifted
from the base by about 5-7.5cm by hand. If you observe there
are occassional pauses as you are walking normally, it means the
belt has become loose. Over time the tread belt will loosen due to
wear or stretching and an adjustment must be made.
The Treadmill
will not speed
up slow down
Please call our Customer Service Centre on
1800 802 924.
The Display
Screen does
not work
Please call our Customer Service Centre on
1800 802 924.
The Treadmill
is losing speed
Add lubricant oil to the underside of the tread belt as per
instructions on page 7 of this manual.
Display Screen
is on but the
Treadmill does
not start
The treadmill has not been started according to the instructions
on pages 7-11 of this manual. If the treadmill still does not start
please call our Customer Service Centre on 1800 802 924.
Unreadable
/ Incoherent
Display Screen
Motor is overheating. Turn the power off, unplug and leave for one
hour then restart. If it does not restart please call our Customer
Service Centre on 1800 802 924.
The belt is
running to
the left
4. Turn the right screw clockwise or the left screw anticlockwise
by half a turn using the allen key. Start the WalkSlim Mini
Walk 670 to check the new position of the belt.
5. If the belt is still not in the middle repeat the action until
adjusted to a central middle position.
6. After adjusting the belt to the middle, start the WalkSlim Mini
Walk 670, set to the maximum speed and observe the tread
belt to ensure that is running smoothly. If it’s not centralised,
then repeat the adjustment steps again.
Tread belt adjustment holes
13
IT
