2. The Manual Remote Control Mode
This mode will use the Remote Control to adjust your speed
• Stand in the Constant Zone and hold the Start/Stop Button on the Remote Control
for more than 1 second to start the treadmill.
• Press the Increase Speed Button to speed up increasing speed by 0.1km/hr
• Press the Decrease Speed Button to slow down decreasing speed by 0.1km/hr
• When the speed is reduced down to 1km/hr, the treadmill will stop running automatically.
• To stop the treadmill while walking/running, press the Start/Stop Button for more
than 1 second to stop the treadmill.
SYNCING YOUR WALKSLIM MINI WALK 670 WITH THE REMOTE CONTROL
Your remote control is synced to the treadmill during manufacture so a re-sync is only
necessary if you are replacing the first remote with another one.
To re-sync your new remote control
1. Remove the battery cover on the backside of the remote, remove the battery out of
the remote and place it back in again into its correct position.
2. Switch the treadmill on by pressing the Start/Stop Button, once the display panel is
lit, press the Mode Switch Button.
3. If the re-sync is not successful, switch the treadmill off, and repeat steps 1 & 2 again.
• The Display Screen will indicate when the Remote Control Mode is used to start
the treadmill
• During your exercise session, the Mode Switch Button can be used to switch
between the 3 Zone Sensor and the Remote Control modes
AUTOMATIC PROTECTION
• If the treadmill is used consistently for more than 99 minutes the unit will turn
off as a safety feature.
Start/Stop
Powers on and off the treadmill
Mode
Switch between the Automatic
(3 Zone Sensor) Mode and the
Manual Remote Control Mode
Increase/Decrease Speed
Increase speed by 0.1km/hr
Decrease speed by 0.1km/hr
IT
10
