Maintenance
Daily Maintenance
• Regular comprehensive cleaning will extend the life of your WalkSlim Mini Walk 670
• Always turn the power off at the power outlet and make sure there is no moisture
before daily cleaning and maintenance.
• Clean dust out regularly and ensure the exposed parts of the tread belt are clean.
• Wear clean sports shoes to avoid any dust or impurities getting into the tread belt
and board.
• Use a damp cloth with soap or detergent to clean the tread belt. Do not use excessive
water and avoid leakage to the electrical parts.
• Disconnect the power cord when the WalkSlim Mini Walk 670 will not be used for a
long time.
• Do not store the treadmill in the bathroom or outside and avoid areas with a lot of
moisture.
Troubleshooting
The treadmill
is not working
• Make sure the power cord is properly secured into the power
outlet and that the switch is turned to the ‘ON’ position.
• Check the Safety Lock is in the correct position.
• Ensure you are completing the three steps forward procedure
to start your Walkslim Mini Walk 670, as explained on Page 8
of this manual.
• Ensure you are not starting too slowly. The interval between
steps cannot be longer than 1.5 seconds and must be
continuous.
• Ensure the Walkslim Mini Walk 670 is not in sleep mode.
• Ensure you have not been using the Walkslim Mini Walk
670 for more than 100 minutes continuously. It will stop
automatically after this time.
The tread belt
is not working
• Insufficient lubrication. Add silicone oil lubricant.
• Tread belt is too tight. This will reduce motor performance
and increase wear of rollers and tread belt. Adjust tread belt
tightness to the correct tension. The tread belt should be able
to be lifted from the base by about 5-7.5cm by hand.
IT
12