PROBOIL.2X user & installation guide v1e-2
9
Heating indicator:
Displays when the boiler is in a heating stage indicating the boiler is re-heating the
water inside to achieve the pre-set target temperature.
It is normal for the heating indicator to switch off before the target temperature is
achieved as remaining heat inside the unit is still to disperse fully into the stored water.
Red colour, constantly illuminated when heating element is on (unless in standby
mode).
Thermometer symbol:
Red colour, constantly illuminated when the unit is not in standby mode.
Filter life indicator bars:
Displays the used and remaining time until the filter cartridge must be replaced.
On initial power on or after the counter is reset it will display the following bars 1 x red,
1 x orange, 6 x blue
As time passes blue and orange bars will disappear indicating the expired time.
When all the bottom bar is flashing red you must replace the filter cartridge
regardless of the amount of usage both to protect the internal components of the
boiler and ensure hygiene. Each filter has a usable life of 6 months.
If the filter life is exceeded the product will beep daily to serve as an audible reminder.
We also operate a free reminder service when you register online.
In the event that power is interrupted to the boiler the filter counter will be reset
accordingly we also recommend you write the installation date on the filter label.
Pressing and simultaneously holding both
-
&
+
buttons for apx. 1 Second will reset
the filter life timer.
The 2 digit “multifunction” display:
Displays various information depending on the status of the boiler and the last key
press:
1)
Current in tank water temperature:
in normal use (without prior key press) the
current approximate water temperature in the tank will be displayed. To reduce
energy use it is normal for the displayed temperature to reduce by a few degrees
before being reheated back to the target temperature.
2)
Target in tank water temperature:
After either the
+
or
-
key is pressed on the
display the multifunction display will change to show the desired target
temperature, after a moment it will then revert to displaying the current
temperature:
3)
Troubleshooting error codes:
In the event of the boiler self-diagnosing a problem
it will display an
“E”
code to help to diagnose the fault, see troubleshooting
section.
Blue colour, constantly illuminated when the unit is not in standby mode.
