PROBOIL.2X user & installation guide v1e-2
11
7.
Take note of the direction (orientation) of the filter
installed. The “FLOW->” indication on the label
shows the direction of water flow from inlet to
outlet. It is important that the blue flexible pipes
are reinserted back into the same inlet and outlet
sides of the new filter cartridge. You might wish to
mark the blue pipe on the “inlet” side of the filter
with the permanent pen as memory aid for later.
8.
Remove the blue flexible pipe from both ends of
the filter cartridge.
To do this you should push the collet (see drawing)
towards the centre of the filter whilst
simultaneously pulling the blue flexible pipe in the
opposite direction away from the filter.
As the pipes are removed it is normal for a small
amount of water in the pipes and filter to be
released, catch this with the bowl and or cloth.
9.
Check both ends of the blue flexible pipe for any
signs of wear, if the ends of the pipe are badly
worn you must cut away the damaged section
cleanly and squarely using a snip tool, sharp craft
blade or similar.
10.
Push the “inlet” flexible blue pipe firmly and fully
into the new filter cartridge inlet.
