19
1. Washer and screw
2. Screw (4 pcs)
3. Bearing sleeve (2 pcs)
4. Tool DB110
5. Setting lines
1
4
2
3
5
1. Mount the washers and screws in the drive shaft, one from each side.
2. Dismantle the screws (4 pcs) from the bearing sleeves on both sides.
3. Fit the tools in the holes, one from each side. Note! Turn both bearing sleeves
simultaneously approx. 165° until the setting lines in the bearing sleeves are aligned
with the setting lines in the housing. If not done carefully, drive unit can be damaged.
4. Remount the four screws in the bearing sleeves and dismantle the washers and screws.
CHANGING THE DIRECTION OF ROTATION
The direction of rotation can changed by using tool DB110.