error detectIon and solutIons
21
If the error repeats or persists, the wallbox must be cooled and/or shaded more ef-
fectively at the installation site. Should the error persist, please contact the specialist
electrical contractor who has performed the installation to have the error resolved.
PLEASE NOTE:
In general, the
eMH3
is engineered for operation in high ambient tem-
peratures. However, it must be ensured that the maximum operating
temperature is not exceeded through external influences such as direct
sunlight or similar. Otherwise, more effective cooling and/or shading at
the installation site must be ensured.
200 ms 200 ms 200 ms 200 ms 200 ms 200 ms 200 ms 200 ms 200 ms 200 ms
Description
Error F16:
Data transfer to
the integrated electrical cur-
rent monitor is disrupted. The
maximum charging current is
limited to 10 A while this error
occurs.
The blue and the green LED are continuously ON, the
red LED flashes twice.
Solution:
Charging operations can continue, but the charging output will be reduced.
Should the error repeat or persist, please take the wallbox out of operation (see “Tak-
ing the product out of and back into operation” on page 22 ) and contact the special-
ist electrical contractor who has performed the installation to resolve the error.
200 ms 200 ms 200 ms 200 ms 200 ms 200 ms 200 ms 200 ms 200 ms 200 ms
Description
Error F17:
The temperature
monitor has detected a tem-
perature of between 60° and
80° Celsius inside the hous-
ing. The maximum charging
current will be limited to 6 A.
The blue and the green LED are continuously ON, the
red LED flashes twice.
Solution:
Charging operations can continue, but the charging output will be reduced.
If the error repeats or persists, the wallbox must be cooled and/or shaded more ef-
fectively at the installation site. Please contact the specialist electrical contractor who
has performed the installation to check and resolve the error, or move the installation
site of the wallbox.
WARNING!
Should the wallbox repeatedly or continuously show error codes, please
take it out of operation (see “Taking the product out of and back into op-
eration” on page 22 ) and contact the specialist electrical contractor
who has performed the installation to have the error resolved. Should
the problem persist, please contact ABL technical support. You can find
contact details in section “Contact” on page ii.