Hardware Setup
2-7
Please follow the instructions below to set the
system to SLI mode and install your graphics
cards.
NOTE:
Please handle the switchboard with
caution. Watch out for the sharp edges.
1.
Simultaneously push the two retention clips
at both ends outward to release the switchboard.
Carefully pull the switchboard out of the slot.
2.
Flip the switchboard over to the side
labeled with “SLI”. Carefully insert the
switchboard into the slot.
3.
Slightly push down the switchboard until
the retention clip snap into places. Make sure
the switchboard is completely inserted into the
slot.
4.
Insert the two graphics cards into PCIEXP1
and PCIEXP2 slots on the motherboard.
5.
There are goldfingers on your SLI Graphics
Cards reserved for the SLI Bridge Connector.
User’s Manual
Summary of Contents for NI8 SLI Series
