BIOS Setup
NF-95
3-11
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sectors read/write. If
your IDE hard drive supports block mode (most new drives do), select Enabled for automatic
detection of the optimal number of block reads/writes per sector the drive can support.
Onboard Device
Click <Enter> key to enter its submenu:
Init Display First
This item allows you to choose the primary display card.
On-Chip USB Controller
This option enables or disables the USB controller.
-
USB Keyboard Support via
Select [
BIOS
] (the default setting) for the legacy operating system (such as DOS) that does
not support USB keyboard.
-
USB Mouse Support via
Select [
BIOS
] (the default setting) for the legacy operating system (such as DOS) that does
not support USB mouse.
On-Chip Audio Controller
This option enables or disables the audio controller.
Onboard LAN Controller
This option enables or disables the LAN controller.
-
LAN Boot ROM
This item allows you to use the boot ROM (instead of a disk drive) to boot-up the system and
access the local area network directly.
Summary of Contents for NF-95
