3-12
Chapter 3
DDR DQS Input Delay:
Two options are available: Auto or Manual. The default setting is
Auto
. If you set to
Manual
, then the
next item will be available.
Input Delay Value:
This item allows you to adjust the data input strobe delay time of memory. You can key in the HEX
number into this section.
DDR DQS Output Delay:
Two options are available: Auto or Manual. The default setting is
Auto
. If you set to
Manual
, then the
next item will be available.
Output Delay Value:
This item allows you to adjust the data output strobe delay time of memory. You can key in the HEX
number into this section.
Back to Advanced Chipset Features Setup Menu:
AGP & P2P Bridge Control:
Click <Enter> key to enter its submenu:
CPU to AGP Post Write:
Leave this item to its default setting.
AGP Aperture Size:
This option specifies the amount of system memory that can be used by the AGP device. The aperture is a
portion of the PCI memory address range dedicated for graphics memory address space.
AGP Data Transfer Rate:
This item selects the data transfer rate of AGP device. A higher rate delivers faster and better graphics to
your system. Make sure your graphics card supports the mode you select.
KD7A
Summary of Contents for KD7A
