BIOS Setup
3-11
[Hot Keys]:
Use any of the function keys between <F1> to <F12> to power on the system.
[Mouse Left]:
Double click the mouse left button to power on the system.
[Mouse Right]:
Double click the mouse right button to power on the system.
[Any Key]:
Use any keyboard keys to power on the system.
[Button Only]:
Use only the power button to power on the system.
[Keyboard 98]:
Use the power-on button on the “Keyboard 98” compatible keyboard to power on the
system.
NOTE:
The mouse wake up function can only be used with the PS/2 mouse, not with the COM port or
USB type. Some PS/2 mice cannot wake up the system because of compatible problems. If the specs of
your keyboard are too old, it may fail to power on.
KB Power ON Password:
This item sets the password required in order to power on your computer.
NOTE:
Do not forget your password, or you will have to clear the CMOS and reset all parameters in
order to utilize this function again.
Hot Key Power ON:
This item powers on the system by pressing <Ctrl> key plus one of each function key (<F1> ~ <F12>)
simultaneously.
Onboard FDD Controller:
This option enables or disables the onboard FDD controller.
Onboard Serial Port:
This is used to specify the I/O address and IRQ of Serial Port 1. Six options are available: Disabled
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
AUTO. The default setting is
3F8/IRQ4
.
Onboard Parallel Port:
Sets the I/O address and IRQ of the onboard parallel port. Four options are available: Disable
378/IRQ7
278/IRQ5
3BC/IRQ7. Default setting is
378/IRQ7
.
Parallel Port Mode:
Four options are available: SPP
EPP
ECP
ECP+EPP. The default setting
is
SPP
mode.
EPP Mode Select:
Two options are available: EPP1.7
EPP1.9. The default setting is
EPP 1.7
. When
the mode selected for the parallel port mode is EPP, the two EPP version options are available.
ECP Mode Use DMA:
Two options are available: 1
3. The default setting is
3
. When the mode
selected for the parallel port mode is ECP, the DMA channel selected can be Channel 1 or Channel 3.
PWRON After PWR-Fail:
This setting lets you set the system action after a power failure. Three options are available: On
Former-Sts
Off. The default setting is
Off
.
User’s Manual
Summary of Contents for BD7-E
