Hardware Setup
2-3
2-3. Install System Memory
This motherboard provides two 184-pin DDR DIMM slots for maximum memory expansion up to 2GB.
Table 2-1. Valid Memory Configurations
Bank
Memory Module
Total Memory
Bank 0, 1 (DIMM1)
128, 256, 512MB, 1GB
128MB ~ 1GB
Bank 2, 3 (DIMM2)
128, 256, 512MB, 1GB
128MB ~ 1GB
Total System Memory
128MB ~ 2GB
NOTE:
No hardware or BIOS setup required after adding or removing memory modules.
Power off the computer and unplug the AC power cord before installing or removing memory modules.
1. Locate the DIMM slot on the board.
2. Hold two edges of the DIMM module carefully, keep away of touching its connectors.
3. Align the notch key on the module with the rib on the slot.
4. Firmly press the module into the slots until the ejector tabs at both sides of the slot automatically
snaps into the mounting notch. Do not force the DIMM module in with extra force as the DIMM
module only fit in one direction.
5. To remove the DIMM modules, push the two ejector tabs on the slot outward simultaneously, and
then pull out the DIMM module.
ATTENTION:
Static electricity can damage the electronic components of the computer or optional
boards. Before starting these procedures, ensure that you are discharged of static electricity by touching a
grounded metal object briefly.
User’s Manual
Summary of Contents for BD7-E
