Abilia Gewa Control 10, Manual, Page: 27 / 56

27
Tip! Control 10 can record codes from most IR transmitters on the market with a few
exceptions. You may have problems with a few or all of the functions for a certain IR
transmitter. In these cases it is possible to try another recording method. Instead, do as
follows in step 2; Press
P
and
1
at the same time but keep them pressed for
approximately 2 seconds until the indication lamp for programming flashes green and goes
out. Control 10 is now in another recording mode. Otherwise use the same recording
procedure as above.
Adding a 4096-code
Control 10 is delivered with a special coded channel (4096) on the Code -button
!
. The
code is selected randomly. This coded channel is normally used for functions that require
strict authorization such as apartment or house doors. The code has 4096 different
combinations and has always the same code irrespective of which level you use. If you
have to program a new coded channel there are two methods of doing so.
Method one: record the code from another transmitter, as described under Recording IR
channels from another Transmitter . By this method it's possible to program a coded channel
on any button independently of level.
Method two:
Enter a binary code. The binary code will always be associated with the Code -
button
!
and it is the same for all levels . Make up your own binary code or use the code
already programmed in an IR receiver or transmitter.
There are two types of IR receivers: an older type of receiver where you set the code with a
12-pole switch, or a newer type where the IR receiver is programmable. The principle is the
same when it comes to creating the binary code.
Fig 3 shows a 12-pole switch. Switches 1,
4, 6 and 12 are in the
“On” position, the others are in the “Off” position.
1 2 3 4 5 6 7 8 9 10 11 12
2048 1024 512 256 128 64 32 16 8 4 2 1
On
Off
Fig 3
The following example describes how the binary code is created.
1. Press
P
and
!
at the same time. The indication lamp for the current level are now lit.
2. Enter the code by pressing on
---
or
!
.
---
= switch in Off position and
!
= switch in On position.
Press twelve times in turn;
!
,
---
,
---
,
!
,
---
,
!
,
---
,
---
,
---
,
---
,
---
,
!
, ( Fig 3 ).
3. When you have pressed twelve times the indication lamp for programming flashes green
to show that the operation is finished.
The code is now programmed on the
!
-button. Make a note of the chosen code for
future usage.
Adding a 4096 code
Press
P
+
!
, press
---
or
!
12 times.
---
= Off position.
!
= On position.
Default setting: Random code