Abilia Gewa Control 10, Manual, Page: 26 / 56

26
Recording IR Channels from another Transmitter
Make sure the batteries in both transmitters are fully charged. Do not use the transmitters in
intense light (e.g., sunlight) when programming.
Place the two transmitters on a table with the original transmitter directed towards the rear
of your Control 10, see picture.
1. Choose the level where the channels are to be recorded with
---
. Only one level at a time can be programmed.
2. Press
P
and
1
at the same time. The indication lamp on
button 1 and the present level now flashes.
To check that the transmitters are in the right position, keep
any button pressed on the original transmitter. The indication
lamp for the
Level -button now flashes green. Move the
original transmitter to the left or to the right until the indication
lamp goes out. Then move the original transmitter backwards
until the indication lamp goes out (one meter for certain
transmitters). Place the original transmitter centrally between
these positions. Certain types of transmitters only emit a
short flash each time the button is pressed. In these cases,
press several times.
3. Press and release the button
X
on Control 10, which is to be
programmed. The indication lamp for the Level -button now
emits a steady orange light.
4. Keep the corresponding button
Y
on the original transmitter
pressed. Release the button when the indication lamp for the
Level -button goes green. It might take up to 10 seconds.
If the indication lamp goes orange again press the button one
or more times until the light flashes green and goes out.
If the indication lamp flashes red the programming has failed.
Try once more from step 2.
If a beep is heard the level is locked and no
programming can be made. See section Locking/Unlocking
the Settings Lock how to unlock a level.
5. If the programming of the first button was successful, repeat
steps 3 and 4 until all buttons are programmed. Finish by
pressing
---
.
6. The indication lamp for programming flashes green to
indicate that the programming is complete.
7. Now test the programmed functions on the device which is to
be controlled.
Recording IR Channels
Press
P
+
1
, select button
X
, select button
Y
, then continue or finish with
---
.
Important ! When just one level is used, the Level -button automatically becomes the next
levels first button, see Table 1 . It means that it is possible to record an IR channel on the
Level -button, but only when just one level is being used.
Original transmitter