28
1
= Unlock.
2
= Lock.
Default setting: Unlocked
Recording IR Channels from another Transmitter
Make sure the batteries in both transmitters are fully charged. Do not use the transmitters in intense
light (e.g., sunlight) when programming.
Place the two transmitters on a table with the original transmitter directed towards the rear of your
Control Medi, see picture.
1.
First press
4
and then simultaneously press
1
for 2 seconds. When
you release the buttons the “Setting” alert sounds and the indication lamp
on button 1 flashes.
2.
Press
1
.
3.
Press the button
X
where the channel is to be recorded. The indicator
light for the selected button glows steadily and the “Press” alert sounds.
4.
Press and hold the corresponding button
Y
on the original transmitter
pressed. Release the button when the indicator light for the selected
button goes off and the “Release” alert sounds. This may take up to 10
seconds. If the indicator light glows again and the “Press” alert sounds,
you should press the button one or more times until the “Success” alert
sounds.
If the “Error” alert sounds, the recording has failed. Try again from step 3.
5.
If the recording of the first button was successful, repeat steps 3 and 4
until all buttons are programmed.
6.
Finish by pressing
4
for 2 seconds.
7.
If the action is successful, the “Success” alert sounds. If something goes
wrong or takes too long, the “Error” alert sounds.
8.
Now test your recorded functions on the device that is to be controlled.
Recording IR Channels
Press
4
+
1
2 sec
,
1
,
select button
X
,
select button
Y
,
then continue or finish
with
4
2 sec
Original transmitter
Summary of Contents for 429240-1
Page 1: ...Control Medi Easy User manual Art Nr 429240 1 SE EN NO 5 0 ...
Page 5: ...5 ...
Page 22: ...22 ...
