EN - 15
PP
8 Maintenance and cleaning
4
Remove inlet nozzle
from PP body toward the front by unscrewing it and
replace it.
5
Screw in inlet nozzle
until a short distance in front of the wire feed roll
and secure it in this position with the counter nut
6
The inlet nozzle
is mounted in reverse order.
8.3 Cleaning the wire guide
1
Unscrew the cable assembly on the machine side and bring it into a
stretched position.
2
Unscrew the nut
and pull out the liner
or PA liner and replace it, if
necessary.
3
Clean wire conduit
from both sides with compressed air.
4
Slide adjusted liner or PA liner into wire conduit
and secure it with
the nut
.
5
Connect cable assembly on the machine side to the wire feed unit.
8.4 Torch neck
1
Remove gas nozzle.
2
Remove welding spatter and spray gas nozzle with
ABICOR BINZEL
anti-
spatter agent.
3
Check wear parts for visible damage and replace them, if required.
4
Replace neck liner or wire guide when worn or soiled.
5
Clean the separating point and grease O-rings with silicone-free sealing grease.
NOTE
• In the case of bent torch necks, a liner (plastic)
(outer diameter D =
4.0 mm) must be mounted additionally between inlet nozzle
contact tip.
• The actual length of the liner (plastic)
on the application.
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning the wire guide with compressed air, wear suitable
protective equipment, in particular safety goggles.
