Abicor Binzel MIG/MAG ROBO Series, Operating Instructions Manual

Page: 38 / 88

EN - 18
9 Maintenance and cleaning MIG/MAG ROBO welding torch
7 For a seamless transition to the contact tip, grind the start of the liner to an
angle of approx. 40°. Deburr the cutting edge.
8 Push the tapered liner through the wire conduit to the retaining nipple (4) .
9 Screw on the nut (3) and tighten it with the switch key wrench.
10 Re-attach the equipment parts to the torch head (1) .
9.3 PA liner
1 Use the ABICOR BINZEL sharpener (1) to sharpen the start of the PA liner
to approx. 40°.
2 Guide the PA liner (3) through the wire conduit until it reaches the contact
tip.
3 Slide the retaining nipple (2) , O-ring and nut (4) onto the PA liner (3) , hold
the PA liner taut and tighten the nut.
4 Guide the central connector together with the lengthy PA liner (3) through
the central socket into the wire feed unit.
5 Mark the PA liner directly in front of the rollers and disconnect the central
connector again.
6 Use the ABICOR BINZEL cutter (5) to cut off the PA liner where marked.
7 Sharpen the interface to 40°.
NOTICE
• New and unused liners must be shortened to the actual length of the
cable assembly.
1 ABICOR BINZEL sharpener
2 Retaining nipple
3 PA liner
4 Nut
5 ABICOR BINZEL cutter
Fig. 4 Shortening the PA liner
1 2 3 4
5