Abicor Binzel FES-200, Operating Instruction

Page: 39 / 100

FES-200 6 Putting into operation
BAL.0209.0 • 2019-08-06
EN - 15
6 Putting into operation
1 Connect the torch system (4) , hose and rubber connector to the fume extraction system.
2 Connect the start-stop pliers (3) to the fume extraction system (1) and fasten it to the extraction hose (2) (cable assembly)
of the torch system (4) . (Option)
3 Connect the dedusting system to the compressed air.
4 Plug in mains plug.
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Disconnect all electrical connections.
1 Fume extraction system FES-200
2 Extraction hose (cable assembly)
3 Start-stop pliers, 4 pole (deviating figure possible) 4 Torch system
Fig. 4 Putting into operation
NOTICE
• When fastening the start-stop replace pliers (3) with clamp, make sure that the red dot points in the direction of the
torch system.
1
2
3
4