Abicor Binzel FES-200, Operating Instruction

Page: 46 / 100

EN - 22
BAL.0209.0 • 2019-08-06
11 Disassembly FES-200
11 Disassembly
12 Disposal
For disposal, observe the local regulations, laws, provisions, standards and guidelines.
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus, almost infinitely
recyclable. The plastic materials used are marked in preparation for sorting and separation of the materials for later
recycling.
12.2 Consumables
Oil, grease and cleaning agents must not contaminate the ground or enter sewage systems. These materials must be stored,
transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions of the
safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.) must
also be disposed of in accordance with the information provided by the manufacturer of the consumables.
The disposal of dust collecting bags is subject to special waste regulations. The dust must not enter sewage systems or be
disposed of together with normal household waste. Please observe the local and official regulations.
12.3 Packaging
ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials are always selected with
regard to their possible recycling ability.
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Disconnect all electrical connections.
CAUTION
• Check and wear your personal protective equipment.
• The personal protective equipment includes protective clothing, safety goggles, respirator mask Class P3, protective
gloves and safety shoes.
• Nobody without personal protective equipment may stay near the fume extraction system when it is being
disassembled.
• It is not allowed to clean the fume extraction system using compressed air or a hammer.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.