Abicor Binzel ABIROB A Series, Operating Instructions Manual

Page: 42 / 112

EN - 20
10 Troubleshooting ABIROB
®
A
9.3 Cleaning the torch neck
To increase the system availability of the welding robot, ABICOR BINZEL
offers automated torch cleaning.
1 Remove the gas nozzle.
2 Remove the weld spatter and spray with ABICOR BINZEL anti-spatter
fluid.
3 Check the wear parts for visible damage and replace them if necessary.
4 Replace the equipment kit when worn or soiled.
5 Clean the separating point and O-rings with silicone-free seal grease.
6 Check the TCP after each use or after a collision in the WH alignment jig.
10 Troubleshooting
Please observe the attached ‘Warranty’ document. In the event of any doubts
and/or problems, please contact your retailer or the manufacturer.
DANGER
Risk of injury and device damage when handled by
unauthorised persons
Improper repair work and modifications to the product may lead to serious
injuries and damage to the device. The product warranty will be rendered
invalid if work is performed on the device by unauthorised persons.
• Operating, maintenance, cleaning and repair work may only be carried
out by qualified personnel (in Germany, see TRBS 1203).
NOTICE
• Please also consult the operating instructions for the welding
components, such as the power source, welding torch system,
recirculating cooling unit etc.