4.2.2 Replace pen core:
You can select ball pen refill or plastic pen stylus according
to different writing material (e.g. paper, table, glass, computer screen). Use the
accessorial clip to pull the pen core out, the replace with a new one and press it down.
As follows:
4.2.3
When using the digital pen, please pay attention that:
1. Write within the effective writing area.
2. There should be no obstacle between digital pen and receiver when writing.
3. To get the best writing effect, the pen should not be over-inclined when writing (The
angle between pen and writing surface should not be less than 60 degrees).
4. Don’t hold the pen too low to avoid your finger blocking the signal emitter in the pen
tip.
4.3 Signal receiver instruction
4.3.1 Indicator instruction
Working status
Red light
Green light
Fail to connect the computer, or the voltage of
receiver is too low when used offline.
Off Off
The receiver battery is under low-voltage
alarm.
Rapidly flash
(0.25 seconds)
Caution:
1. Digital pen has power saving function, in some circumstance, it will automatically enter the dormancy
status. In dormancy status, all the function of digital pen will be temporarily disabled. Just press any key
on the pen to awake.
2. In case the digital pen will not be used for a long time, please take the battery out to avoid the power
consumption.
3. When replacing the pen core, twisting the pen core a bit will make the process easier.
4. The pen core used for digital pen is available in supermarket and stationary store, or from ABI.