Do not instal within 10 feet of a pool, spa or fountain
CAUTION:
fixture(s) must be installed in accordance with all local codes and ordinances.
INSTALLATION INSTRUCTION
www.ABBALightingUSA.com
To ensure optimal performance and safety,
it is important to use our fixtures ONLY with
a low voltage landscape transformer. This
transformer reduces the voltage from 120V
to 12V, making it safe and suitable for
outdoor use.
When installing the fixture(s), please follow
these instructions carefully:
1.Before installation, please ensure that
the power is turned off for your safety.
2.To unlock or open the fixture, rotate it
in a clockwise direction.
3.To ensure a proper installation of the
fixture, it is necessary to diligently create a
hole on the wall that corresponds to the
size of the wires. This will allow you to route
the wires towards the main line connection.
To do this, use a drill bit or hole saw that is
the same diameter as the wires. Make sure
to measure and mark the hole accurately
beforehand. Once the hole are made, you
can proceed to install.
3. Attach the wires from the fixture(s) to
the main cable, For best results, we
recommend using
WN12
waterproof wire
nuts (which are sold separately) to ensure
optimal connectivity and protection
against dust, moisture and water damage.
Simply thread the wires through the wire
nut and twist it until it is securely in place.
4. Remember to test the fixture after
making any adjustments to ensure it is
functioning correctly and that the lighting
is set to your preferences.
5.To mount the fixture, start by passing
the provided mounting screws through
both the housing of the fixture. Then,
align the fixture in the wall and lower it
down so that the screws are positioned .
Next, carefully guide the screws down
making sure they are properly seated and
aligned. Use a screwdriver to tighten the
screws until the fixture is securely
attached to the wall.
Be sure to check that the fixture is level
and flush with the wall surface. If
necessary, adjust the position of the
fixture by loosening the screws and
repositioning it before retightening.
6.Once the fixture(s) have been installed
securely,To insert the lightbulb, place it into
the fixture, and to secure or close the fixture,
rotate it in a counterclockwise direction. it's
time to turn on the power and enjoy the
enhanced lighting experience! Locate the
power switch or breaker that controls the
fixture(s) and turn it on.
Take a moment to observe the lighting effect
Remember to regularly maintain and clean
the fixture(s) to ensure optimal performance
and longevity. Refer to the manufacturer's
instructions for specific details on how to
care for your particular fixture.
