ABB TZIDC, Operating Instructions Manual

Page: 35 / 88

Commissioning
42/18-84-EN TZIDC, TZIDC-110, TZIDC-120 35
7.2 TZIDC-110 / TZIDC-120
bieten
1.

Feed in pneumatic supply power
2.

Connect the bus to the bus terminals with any polarity (or supply power 9 ... 32 V DC)
mA
%
C
°
is displayed
3.

Check mount:
• Press and hold down
and ; once the countdown has gone from 3 to 0,
release and ; the unit switches to the operating level, mode 1.x
• Press and hold down and .
• Additionally, press or until operating mode 1.3 (manual adjustment within the sensor
range) is displayed. Release
• Press or to move the actuator into the mechanical end position; check the end
positions; rotation angle is displayed in degrees (for high-speed mode, press and
simultaneously)
Recommended range:
- between -28 ... 28° for linear actuators
- between -57 ... 57° for rotary actuators
Minimum angle: 25°
4.

Go back to the bus level:
• Press and hold down and ; once the countdown has gone from 3 to 0,
release and
mA
%
C
°
is displayed.
5.

Run Autoadjust
• Check that the unit is on the bus level ("REMOTE")
For linear actuators
1)
:
• Press and hold down until is displayed. Release the control button
• Press again and hold down until the countdown ends
• Release ; this starts Autoadjust
For rotary actuators
1)
:
• Press and hold down until is displayed. Release the control button
• Press again and hold down until the countdown ends
• Release ; this starts Autoadjust