TZIDC-110, TZIDC-120
DIGITAL POSITIONER | OI/TZIDC-110/TZIDC-120-EN REV. H
51
Setting the bus address
1. Switching to the configuration level:
• Press and hold down
and
simultaneously,
• additionally quickly press and release
ENTER
,
• Wait for the countdown to go from 3 to 0,
• Release
and
.
The following is now shown in the display:
2.
Switch to parameter group 1.5:
• Press and hold down
MODE
and
ENTER
simultaneously,
• In addition, press
and
.
The following is now shown in the display:
• Release
MODE
.
The following is now shown in the display:
3.
Setting the bus address:
• Press
or
to set the correct value,
• Press and hold down
ENTER
until the countdown goes
from 3 to 0,
• Release
ENTER
.
The new bus address is saved.
4. Switching to parameter 1.6 (return to operating level) and
saving the new settings:
• Press and hold down
Mode
,
• In addition, briefly press
2×,
the following is now shown in the display:
• Release
MODE
,
• Quickly press and release
to select
NV_SAVE
,
• Press
ENTER
and hold down until the countdown goes
from 3 to 0.
The new parameter setting is saved and the positioner
automatically returns to the operating level. It continues in the
operating mode that was active prior to the configuration level
being called up.
Request information
When the device is in BUS operation, the information shown
below can be called up.
Press the following control buttons to access this information:
Control buttons
Action
Cyclic communication:
The set point in % and the set point status
is displayed.
Acyclic communication:
Displays the communication status.
Displays the bus address and operating mode
Displays the software revision
Operating modes
Selection from the operating level:
1. Press and hold
MODE
.
2. Also press and release
rapidly as often as required. The
selected operating mode is displayed.
3. Release
MODE
.
The position is displayed in % or as a rotation angle.
Operating mode
Mode indicator
Position indicator
1.1
Positioning with fixed set
point.
Adjust set point using
or
.
1.2
Manual adjustment* in
the operating range.
Adjust with
or
**
1.3
Manual adjustment*
within the sensor range.
Adjust with
or
**
* Positioning not active.
** For high-speed mode: Press
and
simultaneously.
conf
conf
%
C
°
conf
ENTER
Summary of Contents for TZIDC-110
Page 31: ...TZIDC 110 TZIDC 120 DIGITAL POSITIONER OI TZIDC 110 TZIDC 120 EN REV H 31 Page 2 of 5 ...
Page 33: ...TZIDC 110 TZIDC 120 DIGITAL POSITIONER OI TZIDC 110 TZIDC 120 EN REV H 33 Page 4 of 5 ...
Page 66: ...66 TZIDC 110 TZIDC 120 DIGITAL POSITIONER OI TZIDC 110 TZIDC 120 EN REV H Notes ...
Page 67: ...TZIDC 110 TZIDC 120 DIGITAL POSITIONER OI TZIDC 110 TZIDC 120 EN REV H 67 Notes ...
