1MRS 750109-MUM
Router Option Card for Lon
Star Coupler
RER 111
SROUT
ABB Automation
15
Once the router option card has been programmed, the fibre-optic mode can be
configured for router side A, if required. To enable this, the communication
parameters must be set from router side B. In the fibre-optic mode, the following
items must be programmed for router side A, for example, by using LNT:
- communication speed
- communication port mode, i.e. single-ended, direct mode.
- other parameters related to communication on the L
ON
W
ORKS
network, i.e.
parameters in the configuration structure.
1RWH
If a parameter value has to be changed, extreme care should be taken, because
all parameters are stored in EEPROM memory in the RTR-10 core module and
incorrect settings may cause severe damage to the RTR-10 core module, or even
destroy it completely.
1RWH
For more information about the programming of the RTR-10 core module, see
L
ON
W
ORKS
Router User’s Guide (078-0018-01C).
5.3.1.
Programming the router by using the LON Network Tool (LNT)
$ %HIRUHVWDUWLQJWKHFRQILJXUDWLRQFRQQHFWD3&ZLWKWKH/17SURJUDPWR
WKHV\VWHP
% 6WDUWWKH/211HWZRUN7RROSURJUDPJOREHLFRQ
&RQILJXUHWKHPDQDJHPHQWQRGHVHOHFWLQJ7RROV
Å
1HW$JHQW
Å
&RQILJXUH«
*LYHDQDGGUHVVWRWKHPDQDJHPHQWQRGHVXEQHWQRGH
6DYHWKH1HW$JHQWFRQILJXUDWLRQ
& $GGWKHURXWHUFDUGE\GUDJJLQJWKHURXWHULFRQIURPWKH'HYLFHW\SHV
ZLQGRZWRWKH'HYLFHVZLQGRZ$IWHUUHOHDVLQJWKHPRXVHEXWWRQ\RXFDQ
JLYHDQDGGUHVVWRWKHURXWHUFDUGIRUH[DPSOHVXEQHWQRGH
' ,QVWDOOWKHURXWHUDVIROORZV
6HOHFW&RQILJXUDWLRQ
Å
,QVWDOO1RGHV«
$FWLYDWHWKHURXWHULQWKH,QVWDOO1RGHVZLQGRZDQGSUHVVWKH6WDUWEXWWRQ
You don’t have to specify the Neuron Id of the node.
( 1H[WWKH/17SURJUDPZLOODVN\RXWRSUHVVWKHVHUYLFHSLQRIWKHGHYLFH
) $IWHULQVWDOOLQJWKHURXWHUFORVHWKH,QVWDOO1RGHVZLQGRZ
Now the router is logically installed in the system, but it is not programmed. The
router operates as a repeater and it will pass on all messages regardless of the
addresses of the messages.
Next you can program the router to operate as intended. Figure 1.-2, for
example, illustrates a system with two subnets and one router option card. Now
we program the router in the system so that it only forwards messages that are
sent to another subnet (e.g. if node X in subnet 1 sends a message to node Y in
!
Summary of Contents for SROUT
Page 2: ... empty ...
Page 23: ......