BUSCH-/ABB-SECURE@HOME
2CSM600727D0901
72/74
Problem
Cause
Solution
There are events (LED
lit) that have not yet been
acknowledged
Correct the problem, go to system status and
acknowledge the fault: the LED
turns off
automatically
The phone network is not
working properly.
Check that the SIM Card has credit and that there is a
phone network signal
(1)
The details of all GSM related faults can be found in the secondary events list. The faults are
summarized in the following table
(2)
Turns on after a power failure of at least 10 seconds
(3)
Only visible after successful authentication (level 2 user)
(4)
Visible only if the system is disarmed
As indicated in note (1), the details of some GSM related faults or issues can be found in the
secondary events log. When the secondary events list is accessed, GSM related faults are
shown on a screen like the one below.
The following table summarizes the possible types of GSM errors:
#
Fault Type
GSM Status
Description
Note
1
SMS
Spam Clean
The control unit has detected incorrect
incoming messages and is removing them.
This may take a few
minutes.
2
No SIM
GSM OFF
SIM Card not inserted or inserted
incorrectly
3
-105
GSM signal too low (in dBm)
4
Power supply
fault
GSM OFF
No EPS (primary power supply): the modem
is placed in energy saving mode. It is
reactivated only when necessary (voice calls
and/or outgoing SMS)
5
CREG 3
GSM OFF
SIM registration not allowed
The SIM Card may have
expired
6
CREG 0
GSM OFF
SIM registration failed
This status is logged
after 10 attempts
7
SIM PIN
GSM OFF
The SIM contains the PIN
8
MINFO
GSM RST
Modem speed detection error
Event
[n/t]
Date
Time
GSM Fault
Fault type
GSM Status
<Recent Past>
