BUSCH-/ABB-SECURE@HOME
2CSM600727D0901
63/74
By using the arrow keys to highlight the position of the detector and pressing the OK
key, a new detailed window appears, displaying the following information for
diagnostic purposes:
o
Hexadecimal address of the detector.
o
Signal level.
o
Detector type.
o
Detector status. The abbreviations mean:
AL.M
alarm memory
ON
detector contact open
OFF
detector contact close
TAM.
anti-opening tampering
REM.
anti-removal tampering
BATT
battery dead
FLT
general fault
SVIS
supervision fault
EXCL
detector excluded (corresponds to “detector isolated” as provided
for in EN 50131 standard)
o
Receipt date and time.
External sirens
After selecting Sirens as a subsystem, select the relevant device from the list and
press the OK key.
In the new window in the Test line: select the type of sound and press OK: The
selected siren will sound as selected, at a medium volume, for 10 seconds, and its
LEDs will flash.
Contacts
When you select contacts, a list of all available telephone numbers will appear. The
configured numbers are marked with the
►
symbol.
Select the relevant telephone number and press the OK key.
Select the desired test type (Voice Call or SMS) and press OK.
GSM
After 4 GSM has been selected as the subsystem, Diagnostics is started. A scroll bar
appears at the bottom to indicate the time of the check, as shown in the figure
below.
At the end, if no problems have been detected, the message "Ok" appears; otherwise,
any error(s) appear in the window during the diagnostics cycle.
Contacts
Contact 1
Contact 2
Diagnostics
