RAIO-01 User’s manual
13
Chapter 3 – Installation
WARNING!
Follow the safety instructions given in this
guide and in the
Hardware Manual
of the drive.
Mounting
The RAIO-01 is to be inserted into an optional module
slot on either the RMIO board of the drive, or on an
AIMA-01 I/O Module Adapter. The module is held in
place with plastic retaining clips and two screws
.
The
screws also provide the earthing of the I/O cable shield
connected to the module, and interconnect the GND
signals of the module and the RMIO board/AIMA
adapter.
On installation of the module, the signal and power
connection to the drive is automatically made through a
38-pin connector.
Mounting onto
RMIO board
1. Insert the module carefully into SLOT 1 or SLOT 2
on the RMIO board of the drive until the retaining
clips lock the module into position.
2. Fasten the two screws (included) to the stand-offs.
Note:
Correct installation of the screws is essential for
fulfilling the EMC requirements and for proper operation
of the module.
3. Remove the cover of the module enclosure (see
page
).
4. Set the configuration DIP switches of the module to
the required position (pages
) and refit the
cover.
Summary of Contents for RAIO-01
