2TLC
172289M0201
Rev C
5
www.abb.com/jokabsafety
2018-04-17
1 Introduction
1.1 Scope
The purpose of these instructions is to describe the Orion3 Base light grids and to provide the necessary information
required for selection, installation and operation of the safety devices.
1.2 Audience
This document is intended for authorized installation personnel.
1.3 Prerequisites
It is assumed that the reader of this document has knowledge of the following:
Basic knowledge of ABB Jokab Safety products.
Knowledge of machine safety.
1.4 Abbreviations
ACM:
Advanced Configuration Mode
AOPD:
Active Opto-electronic Protective Device
BCM:
Basic Configuration Mode
EDM:
External Device Monitoring
MPCE:
Machine Primary Control Element
OSSD:
Output Signal Switching Device (switching output)
RX:
Receiver
TX:
Transmitter
1.5 Special notes
Pay attention to the following special notes in the document:
Warning!
Danger of severe personal injury!
An instruction or procedure which, if not carried out correctly, may result in injury to the operator or
other personnel.
Caution!
Danger of damage to the equipment!
An instruction or procedure which, if not carried out correctly, may damage the equipment.
NB: Notes are used to provide important or explanatory information.