LMT10 0 A N D LMT 20 0 |
M AG N E TOS T R I C T I V E L E V EL T R A N SM I T T ER S | FF O I/L M T 10 0/ 2 0 0/FF - EN R E V. A
69
Transmitter testing
The transmitter of the LMT Series is designed to return a level
indication and an output based on the position of a float on its
sensor tube If the transmitter is equipped with an HMI, the
level and output will be displayed on the front of the electronics
module
1 Apply power to the transmitter using the typical power setup
for the particular option
2 Move the float up and down the sensor tube
3 Monitor the indication of the level on the HMI to make sure
the indication corresponds to the float position
4 Remove the float to make sure the transmitter responds with
an Alarm Indication and a level indication of ----
5 Place the float back on the sensor tube with the correct
orientation
IMPORTANT (NOTE)
It is possible for the LMT Series to continue providing Fieldbus
communication if the HMI display is not functioning properly If
the HMI indicator on an electronics module fails to operate, it is
recommended that the electronics module be replaced at the
earliest convenience It will not be necessary however to shut
down a transmitter or remove it from service based on an HMI
failure
Fieldbus communication
1 Apply power to the transmitter using the typical loop wiring
2 Connect a Fieldbus modem & power with device
3 Move the float along the length of the probe and monitor the
PV indication on the handheld device
4 The output should indicate the float position based on the
calibration range of the transmitter
Spare parts
Please refer to Figure 3 in this manual for the item in the below
spare part list table
Item no .
Description
Part Number
1
Window cover - aluminum
3KQZ207029U0100
Window cover - stainless steel
3KQZ207030U0100
2
HMI display assembly
3KQZ204001U0000
3
HMI connector
3KXL000273U0100
4
Communication board
3KXL065055U0200
6
Terminal board without surge
AU3066
Terminal board with surge
AU3068
7
Blind cover - aluminum
3KQZ207035U0100
Blind cover - stainless steel
3KQZ207110U0100
8
Agency approved plug (½” NPT)
3KXL000613U2600
Agency approved plug (M20)
3KXL000614U1100
9
Plastic plug (½” NPT)
3KXL000438U0100
Plastic plug (M20)
3KXL000289U0100
12
Standard mounting kit
SPM200-1018-3
Vibration isolator mounting kit
VI-KIT
