ABB i-bus KNX IPR/S 3.5.1, Product Manual

Page: 42 / 44

ABB i-bus ® KNX
Planning and application
42 2CDC502099D0211 Rev. A | IPR/S 3.5.1
4.2.2 Firmware update
The device cannot be updated with the i-bus
®
Tool in KNX Secure mode. In this case, the firmware
update will be possible only with the ETS app “ABB KNX Bus Update.” The app can be loaded free
of charge from the KNX Online Shop.
Select Update mode in the ribbon area. If this should become necessary, the firmware can be updated
using this function.
Important
The firmware must be loaded from the Internet first (
www.abb.com/knx)
. For this purpose the i-bus ®
Tool connects to a server if an Internet connection is available .
An Internet connection is then no longer necessary in order to update the system devices.
Important
During the update process, the KNX bus (TP) must be connected in addition to the IP network (LAN) so
that the KNX parameters can be restored correctly. Otherwise, the update process will fail.
It must be ensured that no voltage failure (KNX or IP) occurs during the update process, otherwise the
device can be destroyed.
Note
The functions are described in the i-bus ® Tool online help.
Note
The i-bus ® Tool must be run with administrator rights for the update process.
Unicast
Select
Unicast
mode in the ribbon area.
This function is available only if the parameter Type of IP communication has been set to Unicast in the
ETS application first.
Note
The functions are described in the i-bus ® Tool online help.