Parameterization
D184B140U02 FSM4000
85
Submenu/parameter
Value range
Comment
As Startup
Copies the current data record in the Fingerprint "as
Startup" (commissioning fingerprint).
Accept
Yes, exit via C/CE
Yes
→
Enter
Submenu
Calibration
Submenu
Enter the current coil temperature to readjust the coil
resistance at 20 °C. Perform adjustment only on a "cold"
device. See also chapter "7.4 Additional information
regarding use of enhanced diagnostic functions".
Coil Temp
Temp.
in
°C -100
...
100
0.0
Submenu
Enter
the
length
of
the
signal
cable.
Note:
Information must be entered to calculate the coil
resistance / coil temperature.
CabLength
Length
[m] 0
...
200
0.0
Submenu
Offset
correction
for
temperature
display.
Temp.
Offset
Temp.
in
°C -100
...
100
0.0
Import RT20
Import the reference resistance for the coil.
See also chapter "7.4 Additional information regarding
use of enhanced diagnostic functions".
Note:
This menu is displayed only when the coil
resistance or coil temperature are enabled as an error or
warning message.
Accept
Yes, exit C/CE
New
500
ohms
Old
450
ohms
Yes
→
Enter
Electr.
Zero
Point
This
adjustment is required in order to use the diagnostic
measurement values for the electrode voltage E1/E2 and
the electrode balance as well as the wiring errors for the
electrode state.
Electr. Zero
Point
Yes, exit C/CE
Display the current (new) and stored (old) zero values for
electrode E1/E2.
Select "Enter" to import the current zero points
Note:
The fluid in the flowmeter sensor must be at
absolute standstill.
New 150 180 µV
Old 200 190
µV
Yes
→
Enter
Electr.
Analysis
Displays
stored electrode zero and current electrode AC
voltage acc. to amount and phase.
Where
N1: Current measured electrode AC voltage E1
N2: Current measured electrode AC voltage E2
A1: Stored zero E1
A2: Stored zero E2
N1: 12 µV 286°
Yes, exit C/CE
N2: 10 µV 283°
A1: 650 µV 133°
A2: 670 µV 135°